15348 Autoloader ALE: Picker wrist sensor isn't working Trendsetter_400/800_Auto Trendsetter_NEWS Call Creo for assistance. If this error is reported, the picker wrist sensor is probably faulty. After moving the picker up and in, but before moving the wrist in, the picker wrist sensor is checked. If it reads low, then this error is reported. The sensor can be temporarily disabled by setting "al pios" to 0. Disabling this sensor will cause the machine to run very slowly, and prevents proper error checking. The sensor may not be close enough to the metal strip on the right side of the picker. The wiring may be faulty, or intermittant. The picker head may not have moved in (sensor only reads true if head in and wrist out). ../commands/picker.xmlCommand: picker ../error_messages/15319.xmlE_ALE_PLATES_STICKING_TOGETHER ../error_messages/15349.xmlE_ALE_BAD_WRIST_CYLINDER ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:03 2008 PST